The Raytech Measuring Systems single axis table is a very versatile gage that allows you to measure lengths, widths, X and Y axis hole locations, hole to hole distances, and with the proper options, squareness, perpendicularity of an edge, camber, and edge wave.

The diagonal gage blocks allow you to take a fast, easy, and accurate measurement of corner-to-corner variation on flat parts with square ends.

The squareness gauge allows you to take measurements of perpendicularity of two cut edges or, by setting both edges to zero with the indicator, you can measure camber on a shear.

The interchangeable probes allow you to measure inside large holes for diameter and location and then, by switching tips, measure small hole locations by placing the pointed probe in the hole and letting it find center.

The new framing length gauge is the perfect way to check the in side length dimension on parts that will be assembled into a frame structure, such as doors, windows, picture frames, etc.

The new notch checking gauge allows you to check the depth and position of notches in sheet metal parts. To check the positions of notches, place the flat edge of the probe against the stop bar, press the zero button on the readout, then place the probe into each of the notches.

Checking the depths is as easy as placing the flat edge against the part, pressing the zero button on the readout, and placing the beveled edge into the notch.

The profile gauge allows you to measure edge lift or profile of cut sheet-metal parts. The Raytech Measuring Systems table is one of the very few ways to measure profile easily and repeatably.